228-466-9994

TRANSMISSION SERVICE & REPAIR

Automatic Transmission Diagnosis and Repair

Whether a transmission repair or replacement, we offer the finest service and pay meticulous attention to detail. We provide our customers with straightforward answers so that they can make knowledgeable decisions. We happily discuss transmission problems over the phone, in detail, presenting different service options and prices, including worst-case scenarios.

Allow us the opportunity to show you why we are the best choice in Bay St. Louis and the surrounding areas for expert diagnosis and transmission service & rebuilds!

Please Note:

A transmission service is different then a “flush”, which only changes the fluid and often clogs the filter with the impurities from the old oil. Our transmission service consists of a road test, removing the transmission pan, a visual inspection, draining the fluid, changing the filter and pan gasket, and adjusting the bands and linkage. This service normally takes between 60 to 90 minutes.

We specialize in:

• TRANSMISSION service, repair and rebuilds

We also offer:

Transmission Diagnostic Procedures

Transmission failures can occur in many ways, from a small light on the dash with no noticeable problems, to whining or grinding noises that leave you stranded. Because many transmission problems are easily and inexpensively corrected, a missed diagnosis could cost you thousands of dollars. The shop you choose should have the equipment and expertise necessary to isolate the small problems from the big ones.

Diagnosis of Simple Transmission Problems

Before work is performed, the transmission problem should have an initial diagnosis. Because we commonly see the same failures within the same type of transmission, some diagnosis can be done in as little as 20 minutes and usually while you wait.

Diagnosis of Complex Computer Controlled Transmission Problems

The transmissions in almost all vehicles built in the last fifteen years are computer controlled. Data is collected from various sensors on the engine and transmission, and calculations are made to control shift timing and firmness. Quite often a failed electronic component will create the illusion of an internal transmission problem.

Scanners do a great job of checking codes and identifying simple electrical transmission problems, however, they are inadequate in solving complex electronic issues, which can take much longer to diagnose. We utilize equipment that allows us to operate the transmission independently of the vehicle's electronic control module, the ‘computer’. We can also monitor specific signals given by the electronic control module to the transmission. This technique eliminates the uncertainty between computer, vehicle wiring, and transmission electronic control issues.

Intermittent Transmission Problems

Some transmission problems are sporadic. These issues, usually electronic, may be difficult to diagnose unless the problem occurs while being driven with test equipment attached.

228-466-9994